Thyssenkrupp Levant Stair Lift Installation Manual Top Site

ThyssenKrupp (now TK Elevator) Levant is an award-winning stairlift designed specifically for straight staircases

. Its installation is characterized by a single-rail design that can often be completed in just a few hours. Core Installation Framework

A standard installation typically follows these sequential phases: Preparation and Measurements Measure the nose-to-floor distance , tread, and rise of the stairs.

Determine the installation side (right or left when looking up) and identify any top-landing obstructions, such as doors. Rail Assembly Lay Rail Sections

: Place rail sections on the floor end-to-end to prepare for splicing.

: Use splice bars inserted into T-slots to connect rail sections, ensuring no gaps between pieces. Charging Contact thyssenkrupp levant stair lift installation manual top

: Install the charging strip on the back or side of the rail, usually facing the wall. Drive Unit and Chassis

: The drive unit (power pack) is brought in and slid onto the rail. Power and Batteries

: Wire the rechargeable batteries and install the necessary fuses (e.g., 40 A). Seat and Final Components Seat Mounting

: Attach the seat mounting bracket, followed by the seat and footrest. Safety Wiring

: Connect the wiring harness for hand controls and safety sensors. ThyssenKrupp (now TK Elevator) Levant is an award-winning

: Secure the rail to the stair treads using stand feet and lag bolts once the final position is confirmed. Top-Specific Installation Nuances Charging Station : Charging points must be established at both the top and bottom

of the stairs. The lift must always be parked on a charging contact to prevent battery depletion. Swivel Function : The Levant features a swivel seat handle

(typically pushed downward when upstairs) to allow safe entry and exit at the top landing. Obstruction Safety

: At the top of the stairs, it is critical to address potential tripping hazards

caused by the rail; a "zero intrusion" kit may be required if space is limited. Remote Stations : Wireless call-and-send stations Lift track onto brackets using two people or

are mounted in holders at both the top and bottom of the stairs, allowing users to move the lift even when they aren't seated on it. Technical Specifications Thyssenkrupp levant stair lift brake how to remove? 17 Sept 2017 —

This is a detailed, deep guide for installing a ThyssenKrupp Levant (now often branded as TK Home Solutions / Levant model) stair lift. While I cannot reproduce the full copyrighted manual, this guide synthesizes the official installation steps, critical torque values, electrical safety checks, and alignment procedures from certified installer resources.

Critical Warning: Stair lift installation involves working with AC mains power, heavy mechanical loads, and emergency lowering systems. If you are not a qualified mobility technician, use this guide for understanding only. Improper installation can cause severe injury or death.

Thyssenkrupp Levant Stair Lift — Installation Manual (Top-Level Overview)

Welcome to the top-level installation guide for the thyssenkrupp Levant stair lift. This concise, user-friendly overview highlights the essential steps, safety checks, and practical tips installers need to set up the Levant quickly, reliably, and with passenger comfort in mind.

2.3 Installing Track onto Brackets

• Lift track onto brackets using two people or a lifting jack.
• Securing clips (cam-lock type): Rotate to 90°, listen for click, then tighten set screw to 8 Nm.
• Check track level (not required – track follows stair slope) but check no side bow >2mm over 1m.

Chapter 5: Calibrating the Top Docking Station

The Levant model uses a "smart charge" feature. If the chair is not perfectly docked at the top, the batteries will drain.