Point-n-measure Digital Tape W5746 User Manual Extra Quality

This post is formatted for a knowledge base, product listing (Amazon, Home Depot), or a support page.

Mode 2: Tape Measurement

Use this mode for short distances or contoured surfaces.

  1. Pull the physical tape measure out.
  2. Hook the end of the tape to the starting point.
  3. Read the measurement on the tape itself, OR if the unit has a digital readout for the tape extension, refer to the LCD.
  4. Retract the tape slowly using the release button or by hand (depending on model design).

10. Frequently Asked Questions (FAQ)

Q: Can I use the W5746 outdoors in sunlight? A: Yes, but the laser dot may be hard to see beyond 30 feet. Use the continuous mode or attach a white target card. Point-N-Measure Digital Tape W5746 User Manual

Q: Is it waterproof? A: No—it is IP54 rated for dust and splashes (light rain). Do not drop in water.

Q: Does it replace a traditional tape measure? A: For straight-line distances up to 50 ft, yes. For curved surfaces or recessed depths (like window jambs), keep a physical tape handy. This post is formatted for a knowledge base,

Q: What is the accuracy spec? A: ± 1/8 inch (± 3 mm) from 2 inches to 50 feet under ideal indoor lighting and matte target conditions.

Q: Why does the measurement change when I move slightly? A: The laser measures absolute straight-line distance. Any tilt or movement changes the hypotenuse, affecting the reading. Always aim perpendicular to the target. Mode 2: Tape Measurement Use this mode for

10. Care & Maintenance

7. Display Icons & Error Codes

| Icon | Meaning | | :--- | :--- | | 🔋 Low battery icon | Replace batteries soon. | | 📏 "Front" icon | Measuring from front edge (tip). | | 📐 Triangle icon | Pythagorean mode active. | | Error Code | Solution | | "Err 1" | Out of range (>165 ft). Move closer. | | "Err 2" | Weak reflected signal. Use a white target or darken the surface. | | "Err 3" | Battery low. Replace AAA batteries. | | "Err 5" | Calculation error in Pythagorean mode. Remeasure both distances. |

Power On/Off

Point-N-Measure Digital Tape W5746: The Complete User Manual

Area Measurement

  1. Press MODE once → □ appears.
  2. Measure length (press ON / MEAS).
  3. Measure width – the area is calculated automatically.
  4. Press MODE to see perimeter.

13. Disposal & Recycling

At the end of its useful life, do not dispose of the W5746 in household trash.