Hi Sharp Dvr Reset Password New May 2026

To reset your Hi Sharp DVR password, follow these steps to regain access to your security system. 🛠️ Quick Recovery Options

If you are locked out, try these common default credentials first: Username: admin Password: admin, 123456, or simply leave it blank Formal Password Reset

If defaults don't work, Hi Sharp recommends a formal reset process to maintain security:

Get the Dynamic Code: On the login screen, click "Forget Password" or "Retrieve Password." Navigate to the "Dynamic Code" page.

Contact Support: Take a clear photo or screenshot of the dynamic code page. hi sharp dvr reset password new

Email Details: Send the photo along with your model number and serial number to sales@hisharp.com.tw.

Enter New Code: Support will provide a temporary code to unlock the unit, allowing you to set a new password. ⚡ Hard Reset Methods (Last Resort)

If you cannot wait for an email response, you can perform a factory reset: Physical Reset Button

Locate the Button: Look for a small pinhole or button labeled "Reset" on the back or bottom of the DVR. To reset your Hi Sharp DVR password, follow

Hold to Reset: While the device is powered on, press and hold the button for 10–30 seconds. You should hear a beep indicating the reset was successful. Internal Jumper Method Open the Case: Power off the DVR and remove the top cover.

Short the Pins: Locate two metal pins labeled J1 or G1 on the motherboard. Use tweezers to connect them, then power the device on for 7–10 seconds until you hear a long beep. To help you faster, could you tell me:

What is the exact model number? (usually found on a sticker underneath) Do you see a "Forgot Password" link on your login screen?

I can provide more specific instructions for your exact hardware version. How to Reset a NVR Without Password: Easy Guide - eufy US Open CMS and go to Device Management

5. Method 3 – Reset via Hi Sharp CMS Software (if previously added)

If you have Hi Sharp CMS (Central Management System) installed on a PC and the DVR was added before:

  1. Open CMS and go to Device Management.
  2. Right-click the DVR → Modify Password or Reset Device.
  3. Some versions allow a force reset without old password if the DVR is connected via LAN with admin rights.

2. Try Default Passwords First

Before resetting, try these common defaults:

If you changed it and forgot it, proceed below.

Method 2: The "Forgot Password" Feature (The "New" Reset)

If the defaults fail, look at the login screen. On newer Hi Sharp firmware (post-2022), there is a "Forgot Password" or "Reset Password" button. Here is the "new" workflow:

  1. Click "Forgot Password" on the DVR’s local screen (via mouse) or the Hi Sharp CMS client.
  2. A window will appear showing a Security Code or Device ID (e.g., S/N: HS-AHD8-12345).
  3. Visit the official Hi Sharp password portal (Usually www.hisharp.com/pwd or a QR code on the screen).
  4. Enter the Security Code and the date shown on the DVR.
  5. The portal will generate a Super Password (or temporary unlock code).
  6. Type this new temporary password into the DVR. It will force you to create a new permanent password immediately.

Pro Tip: If the Hi Sharp website is down, call their support line. Read them the Security Code, and they will generate the reset code for you. Have proof of purchase ready.

6. Preventive tips after reset

Note: Procedures vary by Sharp DVR model. If you provide the DVR model number (e.g., Sharp DVR-xxxx), I can give exact reset steps or codes.