Everstart Battery Charger 60108m Manual !link! [iPad OFFICIAL]

EverStart Battery Charger 60108m Manual: Complete User Guide, Troubleshooting, and FAQs

If you own an EverStart battery charger, chances are you rely on it to breathe life back into a dead car, boat, or lawn tractor battery. The EverStart Battery Charger 60108m is one of the most popular compact, entry-level chargers on the market, primarily sold through Walmart’s automotive section. However, losing the original printed manual is a common issue. Without it, you are left with a plastic box covered in cryptic icons and a pair of alligator clips.

This article serves as your complete EverStart Battery Charger 60108m manual. You will find operational instructions, safety protocols, LED indicator meanings, troubleshooting steps, and where to download a PDF copy of the original manual.

Before Connecting

1. Identify battery type – Remove vent caps on flooded batteries. Fill low cells with distilled water.
2. Clean terminals – Remove corrosion with a wire brush.
3. Choose location – Never connect charger over battery vent openings. Work in a ventilated area.

Step 1: Determine Battery Voltage

Ensure the battery is 12 Volts. The 60108M is designed specifically for this voltage standard. everstart battery charger 60108m manual

Preparing to charge

1. Park vehicle, set ignition OFF, remove jewelry.
2. Clean battery terminals; remove corrosion with brush if needed.
3. If battery is in vehicle, ensure good clamp access; identify positive (+, red) and negative (–, black).
4. For flooded batteries, remove cell caps if topping up electrolyte is necessary — only do this before charging and with caution.
5. Place charger on stable, dry surface away from battery vents.

Parts and controls (typical)

• Power cord and plug
• Positive (red) and negative (black) clamp leads
• LED indicator cluster (Power, Charging, Charged, Fault)
• Charging mode selector (if present) — e.g., Normal / Fast / Maintenance
• Fuse or circuit breaker (internal)
• Ventilation slots / thermal cutout

Step 2: Connection Sequence (Crucial)

The EverStart Battery Charger 60108m manual emphasizes connecting to the battery before plugging the charger into the wall. This prevents sparking at the battery terminal.

For negative-ground vehicles (most cars): Identify battery type – Remove vent caps on

1. Clip the red (positive) clamp to the positive (+) battery terminal.
2. Clip the black (negative) clamp to a heavy metal part of the vehicle chassis, away from the battery and fuel line.
3. Do not connect to the negative terminal directly unless the battery is out of the vehicle.

For batteries removed from the vehicle:

1. Connect red to positive (+).
2. Connect black to negative (-).
3. Place the battery on a stable, non-conductive surface.

Step 5: Disconnecting

1. Unplug the AC cord from the wall outlet.
2. Remove the black (negative) clamp.
3. Remove the red (positive) clamp.

Q: Can I use this on an Optima (AGM) battery?

A: Yes. Select the AGM mode using the Type button. The AGM setting lowers the absorption voltage to prevent drying out the internal separators. Step 1: Determine Battery Voltage Ensure the battery

5. Troubleshooting Table (Typical from manual)

| Problem | Likely Cause | Manual Solution | |---------|--------------|------------------| | Green light instantly on | Battery already full, or battery sulfated | Try 2A mode for 24 hours to desulfate | | Yellow light stays on forever | Battery won't hold charge | Load test battery – replace if below 10.5V | | No lights, fan not running | Dead AC outlet or blown fuse | Test outlet with lamp; replace charger fuse | | Reverse polarity light flashing | Clamps on wrong terminals | Swap clamps immediately |