Asmaco Spray Paint Sds -
The product is classified as a hazardous substance due to its pressurized and flammable nature.
Flammability: Extremely flammable aerosol; contains gas under pressure that may explode if heated. Health Hazards:
Inhalation: May cause drowsiness, dizziness, and respiratory irritation.
Skin/Eye Contact: Causes serious eye irritation and mild-to-moderate skin irritation.
Ingestion: Harmful if swallowed; suspected of damaging fertility or the unborn child. 2. Composition & Ingredients Primary hazardous components typically include: Xylene Isomers: Solvent carrier. Acetone & Methoxy Propanol: Rapid evaporation solvents. Butane & Propane: Pressurized propellants. 3. First Aid Measures In case of exposure, follow these immediate protocols:
Inhalation: Move the person to fresh air immediately. Seek medical attention if breathing is difficult. asmaco spray paint sds
Eye Contact: Flush with large amounts of water for at least 15 minutes, removing contact lenses if present.
Skin Contact: Wash the affected area thoroughly with soap and water; remove contaminated clothing.
Ingestion: Rinse mouth with water. Do not induce vomiting. Seek immediate medical attention. 4. Handling & Storage ASMACO Spray Paint Safety Data Sheet | PDF - Scribd
1. Product Identification
- Product Name: Asmacó Spray Paint (various colors/finishes)
- Product Use: Aerosol coating for metal, wood, plastic, and masonry
- Manufacturer/Distributor: (Refer to your local Asmacó supplier – e.g., Asmacó (U) Ltd, Kampala)
- SDS Date: (Check your local version; typical revision within last 3 years)
Section 15: Regulatory Information
US TSCA: All ingredients listed.
EU REACH: Compliant as applicable.
VOC Regulation: Conforms to local VOC limits for aerosol coatings.
SARA Title III (313): Contains toluene, xylene (reportable).
WHMIS (Canada): Class B5 – Flammable aerosol.
Section 11: Toxicological Information
Acute toxicity: Low oral and dermal toxicity but high risk from inhalation. LC50 (rat, 4 hr) for mixed solvents ~10–20 mg/L. The product is classified as a hazardous substance
Skin corrosion/irritation: Mild to moderate irritant; repeated exposure may cause defatting and dermatitis.
Eye damage: Severe irritation possible with direct liquid contact.
Carcinogenicity: None of the ingredients are listed as carcinogens by NTP, IARC, or OSHA, except ethylbenzene (possible carcinogen) in some formulations.
Reproductive toxicity: Toluene is associated with developmental toxicity. Use only with adequate ventilation.
Section 3: Composition/Information on Ingredients
| Chemical Name | CAS No. | Weight % | |---------------|---------|-----------| | Acetone | 67-64-1 | 15–25 | | Propane/Butane (propellant) | 74-98-6 / 106-97-8 | 20–30 | | Toluene | 108-88-3 | 10–15 | | Xylene (mixed isomers) | 1330-20-7 | 5–10 | | Ethyl acetate | 141-78-6 | 5–10 | | Pigments (e.g., Titanium dioxide) | 13463-67-7 | 1–5 | | Resins & Additives | Proprietary | Balance | P210 – Keep away from heat
Note: Exact percentages vary by color and finish. Contact Asmaco for specific color formulations.
11. Toxicological Information
- Acute toxicity: Harmful if inhaled (narcotic effects).
- Skin corrosion/irritation: Prolonged contact may cause defatting and dermatitis.
- Carcinogenicity: Some solvents (toluene, benzene) listed as possible carcinogens – refer to local SDS.
- Reproductive toxicity: Avoid during pregnancy.
Section 2: Hazard Identification
GHS Classification:
- Aerosols – Category 1
- Flammable Liquids – Category 2
- Skin Irritation – Category 2
- Eye Irritation – Category 2A
- Specific Target Organ Toxicity (Single Exposure) – Category 3 (Narcotic effects)
- Aspiration Hazard – Category 1
Signal Word: DANGER
Hazard Statements:
- H222 – Extremely flammable aerosol.
- H229 – Pressurized container: May burst if heated.
- H225 – Highly flammable liquid and vapor.
- H315 – Causes skin irritation.
- H319 – Causes serious eye irritation.
- H336 – May cause drowsiness or dizziness.
- H304 – May be fatal if swallowed and enters airways.
Precautionary Statements:
- P210 – Keep away from heat, sparks, open flames, hot surfaces. No smoking.
- P251 – Do not pierce or burn, even after use.
- P261 – Avoid breathing dust/fume/gas/mist/vapors/spray.
- P271 – Use only outdoors or in a well-ventilated area.
- P280 – Wear protective gloves/protective clothing/eye protection/face protection.
- P410+P412 – Protect from sunlight. Do not expose to temperatures exceeding 50°C/122°F.